THE ZORO HD

The Zoro HD headphones are primarily made out of glossy plastic (piano crafting varnish) which gives them the very low weight of 147g.

I was actually surprised to see that the Zoro HD is even smaller than the Jabra REVO Wireless headset.

Noontec has placed their logo on the exterior of both earcups.

The product name is placed on both sides just over the two headband joints.

Left/Right markings are placed on the interior right above the earcups.

The 3.5mm input port is placed at the bottom of the left earcup.

Both earcups feature a protein skin-friendly material which according to noontec is breathable and will not instigate skin allergies through long term usage (all i know is that it looks nice and is quite soft).

The material on the interior of the headband is not much but regardless we had no issues with it since it’s enough for the lightweight design of the headphones.

You can extend the headband a total of 25mm on each side via 10 visible increments.

As seen on the previous page the Zoro HD can fold to reduce their size and make it easier to carry. The hinges are reinforced with steel so it takes a bit more power to fold the headphones but that's a good thing in the long run.

The company name and logo are also placed on the exterior of the headband.

Noontec has used a special material called TPE (Thermoplastic elastomer) to make the flat audio cable and has also added an in-line microphone along with an answer/end call button.

Both 3.5mm connectors are gold plated and have the company logo placed on them.