THE BLACKVUE DR550GW-2CH

Both the front and rear cameras follow the same cylindrical design but the rear one is half the size of the front. To be more specific the front camera measures 118.5mm in length and 36mm in diameter while the rear measures 67.4mm in length and 27.6mm in diameter.

The 2.4MP Exmor CMOS sensor by SONY has an angle of 137 degrees and is capable of 1080p Full HD recording at 30 frames per second.

At the rear of the front camera we see the recording and GPS activity LEDs right next to the speaker.

On the right side of the camera there's a Wi-Fi activity LED and an audio on/off recording motion sensor (just swap your finger there and it will turn audio recording on/off).

Moving on the left side we find the coaxial port used to connect both cameras, the DC in port and the Wi-Fi on/off button.

The microSD card slot (and the bundled microSD Class 10 card) is placed beneath the protective cap.

Pittasoft uses permanent adhesive tape to secure the front camera onto your car (luckily it's not permanent you can remove it if for example you make a mistake when positioning it).

Fortunately the camera is not connected with the mount so you can remove the main body by pushing the lock button.

The 1MP rear camera uses lens capable of 720p HD recording at 30 frames per second and 139 degrees angle but we don't have any more details on it.

This time over the camera only has a coaxial port on the right side and an activity/power LED on the left side.

The mount of the rear camera also uses adhesive tape but it doesn't have a lock button so you can just remove the main body just by pulling it.