THE A40

Aside the slightly smaller radiator the A40 shares the same sized pump/waterblock combo.

The aluminum radiator is just 27.5mm thick and actually that’s what many other manufacturers have chosen for their AIO solutions as well.

Just like with the radiator used in the A80 the one used in the A40 has an FPI of 20.

Both PA (Polyamide) tubes are 10mm in diameter and 350mm long (just like the ones used with the A80).

With a diameter of 88mm the pump/base combo is the largest one we've seen with an AIO model and yes it’s the same one used with the A80.

Since the pump is not alone this time over you will need to use a SATA power connector as well as the 4pin PWM mainboard connector.

Unfortunately since the PA tubes go all the way inside the housing of the pump they can’t move left and right as much as in other AIO models.

The 70mm airflow fan can spin up to 3000RPM to produce up to 25CFM of airflow with up to 27dBA of noise.

CRYORIG has designed the mount of the airflow fan in such a way that you can position it either to push air towards the mainboard components or away from them.

The all-copper waterblock comes ready with a pre-applied layer of thermal conductive material.

The two QF120 performance 120mm PWM fans can spin up to 2200RPM to produce airflow levels of up to 83CFM with 37dBA of noise.

Once again CRYORIG has used fans that feature rubber pads/mounts on all 4 corners so you don't have to worry about vibrations making it to the radiator.

Well we're good to go so let’s see what CRYORIG has to offer with their A40 hybrid liquid cooler model.