THE WATER 3.0 RIING RGB 360 EDITION

The 392mm long radiator is identical to that of the Water 3.0 Ultimate AIO model.

I was hoping to see a thicker model than last time but again the radiator used is just 27mm thick.

For some strange reason this radiator has an FPI count of 21 instead of 24 (perhaps our tool needed calibration).

We were surprised to see that the 326mm long tubes are now sleeved and thus more durable without sacrificing flexibility.

Just like with the Water 3.0 Ultimate the rather thin pump/waterblock combo doesn't have a LED at the top.

Again both tubes can rotate up to 100+ degrees to further simplify installation.

The all-copper base features a thin pre-applied layer of thermal conductive material.

The three 120mm Riing RGB fans can spin up to 1500RPM to produce up to 40.6CFM of airflow with 2.01mmH2O of static pressure and 26.4dBA of noise.

They also feature anti-vibration pads on all four corners (these fans took their name because of the LED ring place on their interior).

With the fans installed the radiator becomes roughly 53mm thick.

The smart fan controller is not very small but it allows you to connect all three fans onto it and control their speed and 5 LED modes.

With all three fans plugged into the smart fan controller we're now good to go.

As always prior to actually mounting the AIO liquid cooler onto our system we turned it on to check for possible leaks or problems and as expected it looks great (looks even better live).