THE HYDRO H60 (2018)

Once again we find ourselves looking at the usual AIO configuration so the Hydro H60 is nothing new in terms of design.

The radiator used this time over is roughly 27mm thick and features an FPI (fins per inch) count of 18.

CORSAIR has equipped the latest Hydro H60 with 230mm long low permeation rubber tubes.

Just like the H115i/H150 Pro RGB models the new Hydro H60 shares the same pump/waterblock combo.

A small fill/drain port is located on the left side of the pump (not ment to be used by end users).

To make your life easier when installing the cooler both tubes can rotate from the pump/waterblock combo as seen above.

The copper coldplate comes ready with a pre-applied layer of thermal conductive material.

Although similar in design to the fan used with the 2013 version this time over the SP series 120mm PWM fan used can reach speeds of up to 1700RPM to produce up to 54.2CFM of airflow with just 28.3dBA of noise.

With the fan mounted the radiator thickness climbs to roughly 52mm (for maximum cooling results you can have the fan suck air from the outside - providing of course that your system has top exhaust fans).

Here we see the white LED illuminated CORSAIR logo ontop of the pump/waterblock combo (remember to always power the AIO prior to mounting it on your system. Leakage issues are indeed extremely rare but possible).