THE CYLON PRO EXTERIOR

The Cylon Pro is a medium sized mid-tower that measures 491mm in height, 434mm in depth and 219mm in width.

As with most similar cases the entire right side panel is made out of tempered glass (remember the Cylon Pro is also available with an acrylic side panel).

The fascia is made entirely out of plastic and has an RGB LED strip at the front which is controlled via a small button located at the top.

Of course, you can remove the fascia by pulling it from its base to access the interior fan/radiator area.

Here you can mount up to three 120/140mm fans or a 240mm radiator (you should also be able to mount a 360mm radiator if you remove the HDD cage located at the base of the tower).

The I/O is located at the top of the tower and includes the on/off power button, power/HDD LEDs, reset button, headset and microphone 3.5mm ports, two USB 2.0 ports and a USB 3.0 port.

Most of the top area is covered by a magnetic air-filter beneath which you can install again either three 120/140mm fans or a single 240mm radiator.

At the rear of the case we find an 120mm exhaust fan, 7 PCI expansion slots and the PSU area.

Turning the case over we find a removable air-filter right under the PSU area (unfortunately not a magnetic one).