THE FULMO ST EXTERIOR

Although the Fulmo ST is not something extraordinary in terms of design largely thanks to the many corners and the meshed bezel that starts at the lower front and expands all the way to the rear top it looks very nice.

Our version came with a large acrylic panel on the left side.

Roughly 80% of the front fascia is meshed to make things easier for the two 120mm blue LED fans sitting behind the company logo.

Typical for midi towers the Fulmo ST has 3 5.25" optical drive bays.

The top I/O panel includes the on/off and reset buttons, the fan speed controller, fan LED on/off button, 2 USB 2.0 ports, 2 USB 3.0 ports and the usual 3.5" headphones/microphone ports.

Beneath the meshed area at the top of the case you can install up to two 120/140mm fans or a 280/240mm radiator.

The center section of the right side panel extends outwards thus allowing more space for cable management behind the mainboard tray.

Moving at the rear we see an 120mm fan area, 3 water cooling grommets, 8 horizontal PCI expansion slots, 1 vertical expansion slot (for use with fan controllers etc.) and the PSU area at the bottom.

Enermax ships the Fulmo ST with a rear 120mm exhaust fan.

Both side panels are secured in place with the use of regular rubber coated thumbscrews.

At the bottom we see two removable fan filters and 4 thumbscrews at the center of one of those (we will see the why later on).