THE MONSTER II EXTERIOR

The front of the Monster II is quite simple and since it's designed to mask the two 5.25" bays I’d say it can fit everywhere (size wise it measures 445mm in height, 410mm in length and 210mm in width).

Almost half the left side panel is taken by a clear plastic window.

The fascia is made out of glossy/polished plastic but thanks to its design it actually looks nice.

You can remove the fascia by pulling it outwards.

This reveals a removable air-filter and the 140mm LED intake fan.

The top I/O includes the power and reset buttons, power LED, HDD activity LED, two USB 3.0 ports and the usual microphone and headphone 3.5mm ports.

It's not easy to see but the top is actually perforated.

At the rear we see 7 PCI expansion slots, a 140mm exhaust fan and the PSU area.

The 140mm exhaust fan can be replaced with a 120mm one (or a 120/140mm radiator) and the PCI expansion slots are secured in place via regular screws (there's also a slot cover present).

Moving at the base we see a removable air filter right beneath the PSU area and several holes covered with rubber (more about those on the next page).