THE ENTHOO LUXE TEMPERED GLASS EDITION EXTERIOR

Thanks to its very elegant and clean design the 560mm tall, 550mm wide and 23.5mm deep Enthoo Luxe Tempered Glass Edition can be used by all consumers.

The entire left panel is made out of tempered glass so you can see everything inside the chassis.

Here we see the two left RGB LED strips placed horizontally and vertically.

A nice feature is the two hinges that hold the tempered glass panel and thus you don't have to worry about it falling once you release the screws holding it in place.

The front has a total of three 5.25" optical drive bays and a perforated section taking most of the lower half.

As you can see the I/O is hidden inside a compartment right over the 5.25" optical bays and it includes 2 USB 3.0 ports, 2 USB 2.0 ports, headphone and microphone ports, reset button and the LED strip button.

The on/off power button and the power LED are both placed at the top of the tower.

As you can all see the perforated lower half of the fascia allows plenty of air to reach the two 140mm intake fans.

These fans can be either replaced with two 120mm fans (three if you remove the optical bays) or a 240mm radiator (you should be able to install a 280mm radiator without the optical drive bays).

Behind the fascia Phanteks has also placed a removable air-filter.

The top panel is perforated and features a push to release mechanism (also doubles as an air-filter).

Here we find a single 140mm fan which can either be accompanied with two more 140mm fans or can be replaced with three 120mm fans (you can also mount a 360/420mm radiator here).

Turning the chassis around we see a 140mm exhaust fan (can be replaced with a 120mm fan), 8 PCI expansion slots, perforated section where you can place the reservoir mount and the PSU area.

There are two large removable air-filters at the base of the chassis (can be pulled from the front and rear) along with six small rubber feet.