THE P110 LUCE INTERIOR

At first glance the interior of the P110 Luce looks very spacious (and i bet it is).

Antec ships the P110 Luce with a low-RPM 120mm fan at the front (here you can also mount a radiator but just like at the top 55mm in total thickness is all you have so an AIO cooler could be the best choice).

We've seen a few VGA card holders in the past but the one found in the P110 is by far the easiest to use (its only drawback is that it feels a bit flimsy).

On the PSU chamber cover (the Antec logo is again one of the three RGB LEDs) Antec has placed two small removable drive cages.

Each of these cages can either accommodate two 3.5" drives or one 3.5" and one 2.5" (as seen above).

All 10 PCI expansion slots are secured in place via regular screws.

Taking a look from the other side we see the LED light hub, the cables routed behind the VGA card holder, a vertical drive tray and the bottom drive cage.

The drive cage can accommodate up to two 2.5/3.5" drives and is removable.

With the drive cage installed the PSU area is enough for units up to 200mm in length.

Both the vertical drive tray and the trays found in the drive cage are made out of aluminum.

On the vertical drive tray you can mount up to two 2.5" drives.

Here's the top radiator area from inside the case.