THE QUARTZ PRO EXTERIOR

The Quartz Pro measures 554mm in height, 566.7mm in length and 252mm in width while weighing a total of 17.8Kg.

Once again the entire left side panel is actually a large piece of tempered glass roughly 4mm thick.

As with most pictures in its range the fascia is perforated on both sides to allow air to reach the intake fans.

A second tempered glass panel is located at the front of the tower.

Unlike most cases this time over the front tempered glass panel opens up to reveal two 5.25" drive bays and a large removable air-filter.

Three 120mm RGB fans are located right after the filter and as expected you can replace these with either two 140mm fans or a 240/360mm radiator.

The I/O is located at the top of the fascia and includes two USB 2.0 ports, microphone and headphones ports, power on/off and reset buttons, two USB 3.0 ports, activity and power LEDs and a three speed fan controller.

Just over the 240/360mm radiator area at the top (of course you can also use 3x120mm or 2x140mm fans here) Aerocool has placed a removable magnetic air-filter.

The right side panel is made out of 1mm thick metal and is perforated at the front.

Moving at the rear we find a 140mm exhaust fan (without any LEDs), 12 PCI expansion slots (10 horizontal and 2 vertical ones) and the PSU area.

At the base of the tower we find four long round feet and a removable air-filter underneath the PSU area.