HYPERX NGENUITY

Once you install and launch the NGENUITY software it will check for any compatible HyperX devices and list them on the left side.

From the settings tab you can set the software to launch at start up, minimize it instead of close and check the current software version (December 2019 Beta 2 in this case).

It took more time than usual for the software to detect any firmware updates but it did (it may take up to a minute to complete - you will need to update both the dongle and the mouse itself).

From the lights tab you can pick colors and effects for the dual-zone RGB system (or for each zone individually) and of course set the brightness level and the speed.

As expected, the buttons tab allows you to assign commands to the buttons of the PulseFire Dart but as you can see that doesn't really apply for the primary buttons (you can only swap their commands).

The sensor tab allows you to change the DPI levels of the three available presets, add more presets and assign different colors on each.

You can also check the current battery life, brightness level and the polling rate from the top right cornet tabs.

Some of the colors (dual-single zones) are showcased in the above pictures.