ENGINE 3 SOFTWARE

To download the latest version of the Engine 3 control software you will need to visit the official SteelSeries support/downloads page as seen above.

Once you download and install the software it will automatically check for new firmware updates and if there are any it will notify you.

The update procedure takes roughly a minute to complete and then you are just required to unplug the mouse and then plug it back in.

We had turned enhanced pointer precision on recently to perform some tests on the sensor of the RIVAL 310 something which the Engine 3 software detected.

The SteelSeries Engine 3 is one of the most thorough and yet easy to use software control panels in the market. From here you can program any of the 6 available buttons, set the sensitivity levels, adjust acceleration and deceleration, enable/disable angle snapping, set the polling rate, create macros and of course adjust the RGB illumination for both zones.

Here we've placed some of the available colors and two different ones for the two zones (unlike other gaming mice these zones can be adjusted individually).