THE FLEXSCAN EV3240X

With a diagonal of 80cm (31.5”) the FlexScan EV3240X should cover most people out there.

EIZO has placed their logo on the left leg of the stand as seen above (this time over the stand is not a complete ring like with past models).

Thanks to the FlexStand monitor stand EIZO has used with their EV3240X it can go as low as just 11mm from your desk (427mm top end).

At its highest point this base can raise the EV3240X up to roughly 206mm from your desk (625mm top end).

A total of 7 touch buttons are located on the right side of the lower bezel.

The two 2W speakers are located on the far left and right of the lower bezel as seen above.

Taking a look at the rear of the screen we see the EIZO logo and the FlexStand.

The on/off button with the power port and a Kensington lock are located on the rear left of the screen while the two HDMI v2.0 ports, DisplayPort v1.2 port, USB-C port, RJ45 port, USB host port and two USB 3.2 Gen1 ports are located on the rear right.

On the far right we find another USB-A 3.2 Gen1 port, USB-C port and the two 3.5mm jacks for headphones and speakers.

Just like past FlexStand models the one used with the EV3240X features an easy to use cable management system.

Unlike most screen stands only part of which swivels thanks to its base the entire EV3895 can swivel up to 90 degrees on either side.

You can also tilt the screen up to 35 degrees upwards and 5 degrees downwards.

Of course, the FlexStand also pivots up to 90 degrees (very useful for some professionals).