THE ISK 600 INTERIOR

Removing the cover is not hard and as you can see even from the side the ISK 600 has plenty of room inside, for an mITX case that is.

At the top we see the 3.5" drive caddy (you can mount one 3.5" drive up and one down) and right next to it the caddy used for either the thin optical drive bay or two 2.5" drives.

Here we see how the caddies look with 3 drives installed.

In order to install the mainboard you obviously need to remove the caddies.

Antec gives you the chance to mount a 3.5" drive vertically on the left side of the case if you decide not to use the caddy.

The PSU area is at the front and as you will later on Antec has used a power cable to reach the power port at the rear.

You can replace the 120mm fluid dynamic bearing fan and its fan controller with a 120mm AIO liquid cooling solution if you want the best cooling for your CPU.

The PCI shields are reusable and are locked in place via regular screws (to release them you first need to remove the external cover).