THE P6 EXTERIOR

The P6 is 405mm tall, 470mm long/deep and 200mm wide so although quite compact it still comes very close to some regular midi towers.

Antec has used a 4mm thick tempered glass side panel with the P6.

As always the side panel is held in place with large but flat thumbscrews.

The I/O is placed on the left side of the fascia and it includes two USB 3.0 ports, headphones and microphone 3.5" ports and the power on/off and reset buttons.

The fascia is made out of plastic and features a white LED logo projector on the base.

You can access the magnetic air filter by removing the fascia as seen above.

Although Antec says that you can place a 240mm radiator at the front it's clear that you can also place a 280mm one.

The entire top is covered by a magnetic air filter and beneath it you can place up to three 120mm or two 140mm fans (you should also be able to mount a 240mm radiator here).

At the rear we find the pre-installed 120mm LED fan, the 4 PCI expansion slots and the PSU area.

Turning the case over we find a removable air filter (not as easy to remove however as the magnetic ones) and four thumbscrews (more about those later on).