THE ULTRAGEAR 34GL750-B

Typically, we start with the base which we need to attach onto the main body of the stand as seen above.

Once that is done the stand is ready to accept the screen.

As with previous models thanks to the 4 openings at the top and bottom of the rear mounting area you no longer need to secure the screen onto the base via screws.

Just place the top of the base into the mounting area like in the above picture (you can remove it if you'd like via the small switch located at the lower rear of the screen).

With a diagonal length of almost 87cm the 34GL750-B is the 2nd largest Ultra-Wide monitor to arrive here.

At the lower stand position the screen sits roughly 87mm from the desk whereas at its highest it sits roughly 210mm.

The base also has a tilt function with a range of -5 to 20 degrees.

Part of the rear is glossy just like the main body of the base.

Here we also find the available connectors (2xHDMI/1xDP/1x3.5") alongside the power port.

You can also attach the bundled cable management addon anywhere on the main body of the stand (the red part of the stand can be removed, however i don't know the purpose of that).