THE MASTERLIQUID 360 ATMOS

In terms of design at first glance at least the MasterLiquid 360 Atmos doesn't look any different compared to most AIO models out there.

With the fans mounted thickness is just under 53mm (the radiator is just over 27mm thick).

With an FPI (fins per inch) count of 20 Cooler Master was right to include high pressure fans.

A fill port which should not be tampered with is placed at the rear end of the aluminum radiator.

The 400mm long braided tubes should be plenty for most PC cases out there.

The default design on top of the pump is obviously the Cooler Master logo but as mentioned already you can replace it with your very own 3D printed model.

Typically, the tubes can rotate around 100 degrees from the base of the pump/waterblock combo.

Cooler Master has placed three Sickleflow Edge 120mm ARGB fans on the radiator which produce both high airflow and pressure (70.7CFM / 3.61mmH2O).

The compact ARGB controller is a useful part of the MasterLiquid 360 Atmos.

The round copper coldplate features a sticker which allows the end user to place thermal paste where it matters most (in most case this isn't really needed but since Cooler Master says so i did just that prior to mounting it).