THE X-PLUS 3

The X-Plus 3 enclosure/chamber weighs 24.3Kg and measures 529mm in height, 511mm in width and 527mm in length.

Everything in regards to the X-Plus 3 is controlled by this 5-inch touchscreen (800x480p) located just over the chamber door.

The door is made out of clear plastic and allows for easy access to the interior.

Such a large and heavy enclosure is not easy to move around for a single person and so QIDI has placed handles on both sides.

Moving at the rear we find the filament spool holder area, filament sensor, on/off power switch, power port, fuse compartment and an RJ45 Ethernet port.

A USB 2.0 port is located at the top rear of the enclosure.

As mentioned earlier the printing bed heats up to 120 degrees Celsius and on top QIDI has placed a flexible HF plate.

By default, the 0.4mm copper alloy nozzle is installed which you can easily swap with the bundled hardened steel one.

Inside the chamber we also see one rear one, one side blower type fan (air circulation fan?) and the independent heater on the lower left corner (at least i think that's the one of the three).

QIDI has also placed a LED strip just over the plastic door which you can turn on/off from the 5-inch touchscreen.