ASSEMBLY

The X-Plus 3 is almost fully assembled from the factory, still you need to attach some things (following the on-screen instructions will do).

Starting from the rear you will need to mount the spool holder as seen above.

Then you will need to prepare the filament dryer box by removing the cap seen above and placing the desiccant pouch in the special compartment.

Afterwards just place the filament inside the dryer box, pass the end from the tip and mount the box with a 40 degree angle as seen above.

With that done you are ready to print, just remember to place the clear plastic top on the enclosure if you plan on printing with materials which require high temperatures in the chamber (not for PLA for example).

Ah, you shouldn’t forget placing the rubber feet beneath the enclosure, trust me, they are needed.